Effect of immersion disinfection on properties of impression materials.
PURPOSE: Dimensional change and wettability were determined for three addition silicones and a polyether impression material after disinfection by immersion for two 30-minute cycles in 2% acid-potentiated glutaraldehyde. MATERIALS AND METHODS: Contact angles of water on disks were measured on a goniometer. Dimensional change was determined by change in distance between two reference lines. Contact angle (degree) and dimensional change (percent) of five samples were measured after 0-, 30-, 60-, and 1,440-minute intervals of storage in air and disinfectant. RESULTS: The contact angle in air increased for two addition silicones and remained constant for the remaining materials. In disinfectant, the contact angle increased for all four materials, with the contact angle of the polyether increasing the least. In air, dimensional change decreased significantly for an addition silicone and a polyether. In disinfectant, the dimensional changes of the addition silicones were not significant, but the polyether increased in dimension after 1,440 minutes. CONCLUSIONS: Two 30-minute cycles of disinfection in 2% acid-potentiated glutaraldehyde reduced wettability, but had little effect on the dimensional change of the addition silicones and polyethers tested.[1]References
- Effect of immersion disinfection on properties of impression materials. Davis, B.A., Powers, J.M. Journal of prosthodontics : official journal of the American College of Prosthodontists. (1994) [Pubmed]
Annotations and hyperlinks in this abstract are from individual authors of WikiGenes or automatically generated by the WikiGenes Data Mining Engine. The abstract is from MEDLINE®/PubMed®, a database of the U.S. National Library of Medicine.About WikiGenesOpen Access LicencePrivacy PolicyTerms of Useapsburg
